Sagiper Installation is a complex and demanding process that requires skilled installers with a high level of expertise and understanding of specific demands regarding this material.
Once the first board is fastened into place subsequent panels are hooked in a tongue and groove fashion and the wall is built up.
The installation process starts with placing the aluminum starter strip od J mold base along the top of the mark and fastening to substrate with self-tapping wafer head screws.
Once the first board is fastened into place subsequent panels are hooked in in a tongue and groove fashion and the wall is built up. The rubber mallet is used to tap the top end of each board to ensure each one is full hooked into place prior to fastening the boards to the substrate.
After all boards have been installed the aluminum finishing caps are installed on all ends and corner applications.